Best Prices Bosch Air Filter

This part was the exact part to replace the sensor in my 2005 Saab 9-2x Aero. As soon as the part was installed, the check engine light was cleared. For a fraction of the cost of what the dealer charges, this will do the trick!

This is the best shop-vac I ever used. It has lots of power, many accessories and adaptability. Do yourself a favor and buy this one. It's great.

I triple checked DENSO and AMAZON web pages for the front end O2/Fuel sensors. They say 234-9007 and 234-9009 are "correct" front end sensors for 2000 Camry V6. NOT. The correct sensor is 234-4626 for both banks. The -9007 and -9009 sensors trigger CHECK ENGINE light. KEY - The electric connector "TABS" are slightly different. If they don't match the original, DON'T use it. I matched up the TAB configuration for the electric connector on the DENSO web page, which indicated the -4626. My bad ... I shaved the "tab" ends to make the -07 and -09 fit. I now have quasi-new aprox $200 of sensor junk. Paying for an education in O2 sensor hell :-)) Good Luck.

this part is a very low quality piece. after installing this part in my car, the engine ran worse than it originally did. when it comes to parts for your VW/Audi, buy factory parts. do not settle for cheaper brands as they do not work well.

had this on for about two months now. definitely fixed the problem for rough idling, stuttering, stalling. cleared the CEL and car runs great now.....all for an excellant price. Shipping was quick, installation was straight forward and everything fit together perfectly. No issues whatsoever. 97 infinity Q45.

It appears so. If you look through the reviews the "five-star" reviews are almost invariably made by people who also bought several other items in Ramsond's product line and also rated those products five-stars. The most questionable reviews I've seen in a long time. Of the eleven "five-star" ratings only two were "Amazon Verified Ratings". Of the six one, two, and three star reviews (not including this one) five out of six reviewers were "Amazon Verified Ratings".Caveat Emptor.

I purchased this sensor for my Acura RSX Type S 2004. Local auto store checked error code and it was P0135 which means bank 1 sensor 1 is bad. There are 2 oxygen sensors attached to a cat. converter. The sensor 1 is about 3" from the beginning of the converter (closer to the engine) and sensor 2 is located at about the middle. I also purchased the Powerbuilt 648691 Oxygen Sensor Offset Puller which did a great job. I read negative comments about full size socket that they might cut off or damage wires so I decided to go with this short range and no regrets. I didn't even warm up my car and the sensor came off easily. The most difficult part was to disconnect electrical connection. The trick part is: do not take off connectors out of the metal bracket. Just pry a small flat screw driver in the opening located on the side of sensor's connector to release the lock (you will find it because it is the only one out there) and push car's connector away from you. Then take sensor's connector out of the metal bracket. I reinstalled this sensor without any issues for about 5 minutes. It is pretty much the same as to replace a spark plug except you need to get under your car. After driving about 12 or 15 miles the engine light disappeared by itself. Local Acura dealer "Norris Acura West" located in Maryland gave me price $452 + tax and refused to tell me what brand they use and the part number. They have no problem to release such an info for any other Honda parts except…

I bought this vacuum for my garage and use it both to clean the place after working there and to minimize dust generation by connecting it to my tools.I like it very much and use it a lot.Overall this is a great product with just a few things not perfect, which gives it an overall 4 stars.What I like:* The plugging tool function and the available choice to use it or not (2 different settings).* The adjustable power* It moves around very easily, without effortWhat could be better:* Setting up the collection bag in it's chamber is a little bit of a delicate work. Could be more mindless.* The vacuum hose has a small diameter (similar to a household vacuum). Which makes it easy to plug into hand tools but requires adapters (not provided) for any stationary tool. Given its small size it was probably designed to be used only with hand tools and to have a full size shop vacuum for the stationary one.* There is no dedicated way to store on it the vacuum hose. It kind of holds by wrapping it around the handle bar but its not the most stable way.Anyway I recommend buying it and will buy it again if needed.

The item was priced right but i needed it quickly. I found it locally and requested the return authorization number. That was the easy part. No return policy was listed. With the return authorization number I was made aware that there would be a 15% restocking fee. I was aggravated that I hadnt even received the item and now it was costing me 15% for nothing. I would not deal with this company again.